Product Description
Housed and water resistant transmitter. Simply plugs directly into the video and power sockets on the camera. Ideal for wireless outdoor aplications.
- ISM band: 2400MHz to 2483MHz
- RF output power: 10mW
- Digit phase lock loop (four channels)
- Frequency four-channel slide switch PLL control:
- Frequency deviation: 0 to 40 degrees Celsius, +/-200kHz (typical)
- RF output power (Vcc): 12V, 50-ohm load,
- 10mW (minimum), 50mW (typical)
- Video input: 75-ohm impedance, 1Vp-p (typical)
- Audio sub carrier: 5.5MHz (typical)
- Data sub carrier: 6.5MHz (typical)
- Trigger input switch on/off:
- VL: 0.7V
- HI: 4.5V minimum, 5.5V maximum
- Operating voltage (Vcc): 10V (minimum)/12V (typical)/12.5V
- (maximum)
- Operating current (Vcc): 12V (regulated), 120mA (typical)
- Operating temperature: 0 to 40 degrees Celsius
- Operating humidity: 5% to 85%
- Supplied with folding 3dBi gain antenna
Australian Customers Please note:
The maximum allowed (in accordance with the Australian Communications Authority )
2.4 GHz LIPD Video Transmitter output power is 10 milliwatts (mW) EIRP (in Australia). However, increasing the gain of the receiver antenna is an alternative to increasing transmitter output. In very simple terms: increasing antenna gain from 0 dBi to 3 dBi is equivalent to raising the transmitter output from 10 mW to ~ 20 mW, 5 dBi ~ 33 mW, 8 dBi ~ 66 mW, 12 dBi ~ 160 mW, 15 dBi ~ 320 mW, 18 dBi ~ 640 mW, 21 dBi ~ 1280 mW, 24 dBi ~ 2560 mW.
Additional Information
| Manufacturer | No |
|---|
